Capacitor and inductor

Testing Of Diode

         Using Multimeter

Digital multimeters can test diodes using one of two methods:

1. Diode Test mode: almost always the best approach.
2. Resistance mode: typically used only if a multimeter is not equipped with a Diode Test mode.

DIODE TEST METHODE:

• A good forward-based diode displays a voltage drop ranging from 0.5 to 0.8 volts for the most commonly used silicon diodes. Some germanium diodes have a voltage drop ranging from 0.2 to 0.3 V.
• The multimeter displays OL when a good diode is reverse-biased. The OL reading indicates the diode is functioning as an open switch.
• A bad (opened) diode does not allow current to flow in either direction. A multimeter will display OL in both directions when the diode is opened.
• A shorted diode has the same voltage drop reading (approximately 0.4 V) in both directions.

A multimeter set to the Resistance mode (Ω) can be used as an additional diode test or, as mentioned previously, if a multimeter does not include the Diode Test mode.

A diode is forward-biased when the positive (red) test lead is on the anode and the negative (black) test lead is on the cathode.

• The forward-biased resistance of a good diode should range from 1000 Ω to 10 MΩ.
• The resistance measurement is high when the diode is forward-biased because current from the multimeter flows through the diode, causing the high-resistance measurement required for testing.

A diode is reverse-biased when the positive (red) test lead is on the cathode and the negative (black) test lead is on the anode.

• The reverse-biased resistance of a good diode displays OL on a multimeter. The diode is bad if readings are the same in both directions.
  The resistance mode procedure is conducted as follows:
  1. Make certain a) all power to the circuit is OFF and b) no voltage exists at the diode. Voltage may be present in the circuit due to charged capacitors. If so, the capacitors need to be discharged. Set the multimeter to measure ac or dc voltage as required.
  2. Turn the dial to Resistance mode (Ω). It may share a space on the dial with another function.
  3. Connect the test leads to the diode after it has been removed from the circuit. Record the measurement displayed.
  4. Reverse the test leads. Record the measurement displayed.
  5. For best results when using the Resistance mode to test diodes, compare the readings taken with a known good diode.

Measurement of Resistance

Using multimeter

Digital multimeter 

1. Turn power OFF of the circuit . If a circuit includes a capacitor, discharge the capacitor before taking any resistance reading.

2. Turn dial to Ω , which often shares a spot on the dial with one or more other test/measurement modes .

3. First insert the black test lead into the COM jack.

4. Then insert the red lead into the V Ω jack. When finished, remove the leads in reverse order: red first, then black.

5. Connect test leads across the component being tested. Make sure that contact between the test leads and circuit is good.

6. Read the measurement on the display.

7. When finished, turn the multimeter OFF to prevent battery drain.